Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Injector Resistance Test
Turn ignition off. Disconnect fuel injector electrical connector. Using a DVOM, measure resistance between fuel injector terminals. See Fig 1 and FUEL INJECTOR RESISTANCE table. If resistance is not as specified, replace fuel injector.
| Model | (1) Resistance | |||
|---|---|---|---|---|
| EuroVan | ||||
| 2.8L VR6 (Engine Code AES) | 15-21.5 | |||
| 2.8L VR6 (Engine Code AXK) | 13-19 | |||
|
||||
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.