Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Volkswagen EuroVan BaseFACTORY OEM SERVICE PROCEDURE
Toe-In ADJUSTMEN: Rear
- Loosen nut "a" on control arm. See Fig 1 .
- Move control arm forward or back until specification is achieved (vehicle weight on its wheels.) Tighten nut "a" to specification. See TORQUE SPECIFICATIONS . After fasteners are torqued, recheck all wheel alignment settings and readjust as necessary.
NOTE:
If toe-in setting at rear wheels needs adjusting, also check brake pressure regulator setting. Adjust as needed. See appropriate BRAKE SYSTEMS article for specifications.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.