Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Volkswagen Passat GLX, AutomaticFACTORY OEM SERVICE PROCEDURE
External Pages
These are pages that do not belong to the exact selected vehicle (1998 Volkswagen Passat GLS, 4D Sedan, 2.8 D, Automatic), but are still accessible from a link in your vehicle's manual. Be very cautious using repair info from here because these pages may not apply to your vehicle.
- Different variant/trim
- Section 1 (Specifications & Drive Belt Routing - 1.8L)
- Section 2 (1.8L - Engine Mechanical, Fuel Injection Ignition, Engine Code(S): AEB, ATW)
- Section 3 (5 SPD. Manual Transmission 012)
- Section 4 (5 SPD. Automatic Transmission 01V On Board Diagnostic (OBD))
- Section 5 (5 SPD. Automatic Transmission 01V Front Wheel Drive)
- Section 6 (5 SPD. Automatic Transmission 01V Front And All Wheel Drive - External Components, Servicing)
- Section 7 (5 SPD. Automatic Transmission 01V Front And All Wheel Drive - Internal Components, Servicing)
- Different car
- Section 1 (Specifications & Drive Belt Routing - 1.8L)
- Section 2 (Specifications & Drive Belt Routing - 2.8L (ATQ Engine Code))
- Section 3 (Engine Mechanical - 2.8L V6 Aha, ATQ)
- Section 4 (Specifications & Drive Belt Routing (4.0L BDP))
- Section 5 (4.0L - Engine Mechanical, Fuel Injection Ignition, Engine Code(S): BDP)
- Section 6 (2.0L 4-CYL 2V TDI Pd Engine Mechanical, Fuel Injection Glow Plug, Engine Code: BHW)
- Section 7 (1.8L - Engine Mechanical, Fuel Injection Ignition, Engine Code(S): AUG, AWM)
- Section 8 (6 SPD Manual Transmission 01E All Wheel Drive)
- Section 9 (5 SPD. Manual Transmission 01V All Wheel Drive)
- Section 10 (EGR Function Testing - VOLKSWAGEN)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
