1996 Volkswagen Passat GLS, AutomaticFACTORY OEM SERVICE PROCEDURE

Spark Test

WARNING: This page is about a different car, the 1995 Volkswagen Passat. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using an ohmmeter, check resistance of each spark plug wire. See HIGH TENSION WIRE RESISTANCE table. Check for strong Blue spark at coil wire and at each spark plug wire by holding wire terminal 5/16" from ground while cranking engine.
  2. Disconnect and inspect all related ignition system connectors and harness. Clean or repair if necessary. If related connectors and harness are okay, remove negative battery cable. Disconnect secondary and primary leads from ignition coil.
  3. Using ohmmeter, check primary resistance between primary terminals of coil. Check secondary resistance between coil secondary terminal and primary positive terminal. Replace coil if readings are not within specifications. See IGNITION COIL RESISTANCEΒ  table.
HIGH TENSION WIRE RESISTANCE

Application Ohms
Passat (1)
(1) Information not available at time of publication.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.