Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1996 Volkswagen Passat GLS, AutomaticFACTORY OEM SERVICE PROCEDURE

Ignition Timing

NOTE: Always refer to underhood label for latest specifications.

IGNITION TIMING (Degrees BTDC @ RPM)

Application

Checking

Adjusting

1.9L

N/A

2.0L

⁽¹⁾ 12 @ 800-880

⁽²⁾

⁽¹⁾	Scan Tester (VAG 1551) in START BASIC SETTING mode.

⁽²⁾	Ignition timing is not adjustable.

IGNITION TIMING ADVANCE (Degrees BTDC @ RPM)

Application	Specification
1.9L & 2.0L	N/A

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.