Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Volkswagen EuroVan AutomaticFACTORY OEM SERVICE PROCEDURE
Quick Lookups: Fluids
| FLUID CAPACITIES | |||||||
|---|---|---|---|---|---|---|---|
| Fluid Type | Application | Standard | Metric | Fluid Spec | Note | S/H | |
| Air Cond Compressor Oil | w/Front & Rear A/C | 8.00 OZS. | 0.23 L | PAG 46 | S | ||
| Air Cond Compressor Oil | w/Front A/C | 4.50 OZS. | 0.13 L | PAG 46 | S | ||
| Air Cond Refrigerant | N/A | N/A | R-134a | For further details see "Air conditioner specification label". | S | ||
| Automatic Transmission Fluid | 3.70 QTS. | 3.5 L | Automatic Transmission Fluid ESSO Type LT71141 Fluid | S | |||
| Differential Gear Oil | N/A | N/A | Final Drive Filled-for-life. From August 26th 1996 and up use: G 052 145 S2, From August 1990 up to August 25th 1996 use: VW ATF G052 162 A2. | S | |||
| Engine Coolant | 12.20 QTS. | 11.54 L | 50/50 mixture of Ethylene Glycol Base Antifreeze and water | S | |||
| Engine Oil | 6.00 QTS. | 5.67 L | SAE 5W-50, 10W-50 or 10W-60 (Below -20Deg.F to Above 90Deg.F), 5W-30 or 5W-40 (Below -20Deg.F to 60Deg.F), 10W-30 or 10W-40 (Below 10Deg.F to 60Deg.F), 15W-40, 15W-50, 20W-40 or 20W-50 (10Deg.F to Above 100Deg.F) | S | |||
| Fuel Tank | 21.10 GALS. | 79.87 L | S | ||||
| Manual Transmission Fluid | Axle Drive | 2.70 QTS. | 2.55 L | G50, SAE 75W-90 Synthetic Oil | S | ||
| Power Steering Fluid | N/A | N/A | VOLKSWAGEN Hydraulic Oil | Fill between "max" and "min" lines on reservoir. | S | ||
| Windshield Washer Fluid | 7.30 QTS. | 6.9 L | Windshield Washer Fluid | Follow the Manufacturer's Instructions for the mixture ratio. | S | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.