1990 Volkswagen Vanagon Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Spark Test

  1. Using an ohmmeter, check resistance of each spark plug wire. See HIGH TENSION WIRE RESISTANCE table. Check for a strong Blue spark at coil wire and each spark plug wire by holding wire terminal 5/16" ground while cranking engine.
  2. Disconnect and inspect all related ignition system connectors and harness. Clean or repair as necessary. If okay, remove negative battery cable. Disconnect secondary lead from coil Remove primary leads from ignition coil.
  3. Using ohmmeter, check resistance between primary terminals of coil. Check secondary resistance between coil secondary terminal and primary positive terminal. Replace coil if readings are not within specifications. See IGNITION COIL RESISTANCE table.
HIGH TENSION WIRE RESISTANCE

Application Ohms
Fox
Coil Wire With Connectors 1600-2400
Spark Plug Wire With Connectors 4800-7200
Spark Plug Connector 4000-6000
Suppressor 800-1200
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.