1988 Volkswagen GTIFACTORY OEM SERVICE PROCEDURE

Control Unit

The control unit is located on left rear corner of engine compartment on Golf, Golf GT and Jetta models. On Vanagon, control unit may be located in trunk floor behind the rear seat or in the equipment box in cargo area. These units cannot be repaired. The control unit limits maximum engine speed to about 5500-5800 RPM. The control unit receives information from the following:

  • Air quantity from intake sensor.
  • Air temperature from temperature sensor (I).
  • Engine temperature from temperature sensor (II).
  • Exhaust oxygen content from O2 sensor.
  • Position of throttle valve from switch for full throttle enrichment.

The control unit uses this information to determine amount of fuel to be injected.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.