Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Volkswagen Vanagon Base, AWDFACTORY OEM SERVICE PROCEDURE
Fuel Injection System - BOSCH AFC: Testing: Relays: Wiring
- Power supply and fuel pump relays are located in engine compartment. They are both in plastic box on firewall. Fuel pump relay is mounted on right side of box and power supply relay on left.
- Unplug all electrical connectors at injectors. Turn ignition on. Using test light, check for battery voltage (12-volts) at terminals No. 30 and 85 of both relays. Power supply relay should also have voltage at terminal No. 85. If not, check wiring.
- Terminal No. 87 of fuel pump relay should have voltage when starter is operated. If not, check wiring. If wiring is good, check relay. If relay is good, replace ECU.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
