Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Volkswagen Vanagon Base, AWDFACTORY OEM SERVICE PROCEDURE
Oxygen Sensor
- With engine at operating temperature of 176Β°F (80Β°C), check for leaks in exhaust system. Using Adapter (Sun 120 239), connect CO test equipment hose to the sampling point on left exhaust pipe.
- Let engine run about 2 minutes at idle and read CO content. Check function of oxygen regulation. Pull hose off of pressure regulator and pinch off. CO content must rise briefly and then drop again.
- If test is not okay, disconnect connector at pressure regulator and hold control wire to ground. CO should rise. Connect control unit wire connector to connector of alternator. CO should drop.
- If test is not okay, check wire connection on control unit. If test is okay, replace control unit. If test step 2) is not okay, but test step 3) is okay, replace defective oxygen sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
