Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Volkswagen Vanagon Base, AWDFACTORY OEM SERVICE PROCEDURE
Throttle Valve Switch Function
- Disconnect wiring from throttle valve switch. Connect ohmmeter between terminals on lead from switch. Reading should be zero ohms (switch is on) when throttle lever is at idle stop and at full throttle stop.
- To check switch-on point, open and close throttle valve slowly. When ohmmeter indicates switch is on, measure gap between idle stop and idle adjusting screw with feeler gauge. If adjustment is correct, gap should be .002-.004" (.05-.10 mm). Adjust switch if gap is not correct. See ADJUSTMENTSΒ
.NOTE: Proper adjustment of throttle valve switch is important.
- If gap is too large, engine will surge with lean condition. If gap is too small, cold engine will stall at full throttle acceleration. Warm engine will have no deceleration fuel shut-off if gap is too small.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
