1987 Volkswagen Vanagon Base, AWDFACTORY OEM SERVICE PROCEDURE

Deceleration Function

  1. Run engine until coolant temperature is at minimum of 140Β°F (60Β°C) and sensor gives resistance reading lower than 550 ohms. Unplug throttle valve switch connector.
  2. Connect male end of Jumper Plug (VW 1490) to female plug of harness connector. Accelerate engine slightly. Engine speed (RPM) must fluctuate. If not, replace ECU.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.