1987 Volkswagen Vanagon Base, AWDFACTORY OEM SERVICE PROCEDURE

2nd Check

  1. With engine at operating temperature and electrical system off, check for leaks in intake air system. Check ignition timing and idle RPM.
  2. Remove crankcase breather hose and close tightly. Connect Tester (VW 1315 A/1) with Adapter (VW 1315A/2) to idle stabilizer valve.
  3. With engine at idle, nominal value should be about 440 mA (fluctuating). Disconnect connector for oxygen sensor. Nominal value should about 430 mA (constant). If nominal values are not met, replace stabilizer control unit.
CAUTION: DO NOT connect test light to throttle valve switch connectors if ECU is connected.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.