1987 Volkswagen Quantum Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Vacuum Retard Test

  1. Connect tachometer and timing light to engine. Connect Vacuum Advance Tester (VAG 1368 ) according to manufacturer's instructions. Remove both plugs from idle stabilizer (if equipped) and connect together.
  2. Start and run engine at 900 RPM. Disconnect vacuum advance hose from unit and check ignition base timing and idle speed. Adjust if necessary. Disconnect vacuum retard hose from unit. Plug hose.
  3. Bring base timing mark back to pointer by using dial on timing light and read vacuum retard. Retard should be 8-11 degrees. After testing, reconnect idle stabilizer plugs. Reconnect vacuum hoses.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.