1981 Volkswagen Rabbit Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Air/Fuel Mixture Control (Air Flow Sensor)

  1. Remove rubber bellows to expose plate in sensor. Disconnect electrical connectors on auxiliary air valve and control pressure regulator, then operate fuel pump for ten seconds to build up control pressure.
    Fig 1: Checking Air Flow Sensor Operation and Alignment
    G09345285Courtesy of NOT AVAILABLE
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.