1981 Volkswagen Rabbit Base, 2D Convertible, Automatic TransFACTORY OEM SERVICE PROCEDURE

Control Pressure Regulator

The control pressure regulator provides fuel pressure to the top of the plunger in the fuel distributor. Reduced pressure allows the plate to move farther with the same air flow. This supplies more fuel to the cylinders to improve warming up. As the engine reaches operating temperature (or a pre-determined time elapses) the control pressure regulator increases control pressure, leaning the air/fuel mixture.

A bi-metal strip in the control pressure regulator is heated by an electric coil. As it heats up, it gradually increases the control pressure. If the electrical connections are not good, the warm-up function of the regulator will not operate. Some regulators have an altitude-sensitive function that compensates for changes in barometric pressure.

Fig 1: Pressure Regulator (Pressure Compensated Model - Others Similar)
G09345280Courtesy of NOT AVAILABLE
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.