2025 Toyota Crown Signia XLEFACTORY OEM SERVICE PROCEDURE

Quick Lookups: Fluids

FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil 4.30 OZS. 0.12 L Compressor Oil ND-Oil 11 or equivalent S
Air Cond Refrigerant 1.22 LBS. 0.55 KG HFO-1234yf (R-1234yf). HFC-134a (R-134a) S
Automatic Transmission Fluid 4.20 QTS. 3.97 L TOYOTA Genuine Automatic Transmission Fluid Type WS S
Brake Fluid N/A N/A SAE J1703 or FMVSS No. 116 DOT 3 SAE J1704 or FMVSS No. 116 DOT 4 S
Differential Gear Oil 1.80 QTS. 1.7 L TOYOTA Genuine Automatic Transmission Fluid WS S
Engine Coolant Gasoline Engine 6.90 QTS. 6.52 L TOYOTA Super Long Life Coolant or similar high-quality ethylene glycol-based non-silicate, non-amine, non-nitrate and non-borate coolant with long-life hybrid organic acid technology DO NOT use plain water alone. The fluid capacity is the quantity of reference. S
Engine Coolant Power Control Unit 2.10 QTS. 1.98 L TOYOTA Super Long Life Coolant or similar high-quality ethylene glycol-based non-silicate, non-amine, non-nitrate and non-borate coolant with long-life hybrid organic acid technology DO NOT use plain water alone. The fluid capacity is the quantity of reference. S
Engine Oil w/Filter 4.50 QTS. 4.25 L TOYOTA Genuine Motor Oil. JASO GLV-1 SAE 0W-8 SAE 0W-8 is the best choice for good fuel economy and good starting in cold weather. If SAE 0W-8 is not available, SAE 0W-16 oil may be used. However, it must be replaced with SAE 0W-8 at the next oil change. S
Engine Oil w/o Filter 4.20 QTS. 3.97 L TOYOTA Genuine Motor Oil. JASO GLV-1 SAE 0W-8 SAE 0W-8 is the best choice for good fuel economy and good starting in cold weather. If SAE 0W-8 is not available, SAE 0W-16 oil may be used. However, it must be replaced with SAE 0W-8 at the next oil change. S
Fuel Tank 14.50 GALS. 54.88 L S
Windshield Washer Fluid N/A N/A Washer Fluid In cold areas where temperatures range below the freezing point, use washer fluid containing antifreeze. S
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.