2021 Toyota 4Runner TRD ProFACTORY OEM SERVICE PROCEDURE

Removal [08/2015 - ]: Procedure

  1. REMOVE INTAKE MANIFOLD 
    1. Remove the intake manifold (Refer to REMOVAL [08/2015 - ] ).
  2. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    GTY182192Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the sensor connector.
    2. Using a 19 mm deep socket wrench, remove the sensor.
    3. Remove the gasket from the sensor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.