2017 Toyota Prius Prime AdvancedFACTORY OEM SERVICE PROCEDURE

DTC P1C1D-00: Charging Power Low [09/2016 - ]: Procedure

  1. CHECK PLUG-IN CHARGE STATE 

    See step  1

    Result

    Result Proceed to
    DTCs are not output and plug-in charge has been completed A
    DTCs are output or plug-in charge cannot be completed B

    Result: 

    A 

    END (NO MALFUNCTION IN VEHICLE) 

    Result: 

    B 

    REPLACE ELECTRIC VEHICLE CHARGER ASSEMBLY. Refer to  REMOVAL [09/2016 - 05/2019]  , or refer to  REMOVAL [05/2019 - 07/2020]  , or refer to  REMOVAL [07/2020 - ] 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.