Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Toyota 86 Base, Automatic TransFACTORY OEM SERVICE PROCEDURE
OEM System Circuits
- ABS, Hill-Start Assist Control, TRAC, VSC
- Air Conditioning (Automatic A/C)
- Air Conditioning (Manual A/C)
- Automatic Light Control, Light Auto Turn Off System
- Audio System, Parking Assist (Rear View Monitor)
- Back-Up Light
- Clock
- Cooling Fan
- Combination Meter
- Charging
- Door Lock Control
- Data Link Connector 3
- Cruise Control, Electronically Controlled Transmission And A/T Indicator, Engine Control, Shift Lock
- Engine Immobiliser System (W/O Smart Key System)
- EPS
- Engine Immobiliser System (W/Smart Key System), Smart Key System, Starting (W/Smart Key System), Steering Lock, Wireless Door Lock Control (W/Smart Key System)
- Front Fog Light
- Front Wiper And Washer
- Ground Point
- Headlight Beam Level Control
- Headlight
- Horn
- Interior Light
- Ignition
- Key Reminder, Light Reminder
- Luggage Compartment Door Opener
- Multiplex Communication System (CAN)
- Power Outlet
- Power Source
- Power Window
- Remote Control Mirror
- Mirror Heater, Rear Window Defogger
- Seat Belt Warning
- Seat Heater
- Stop Light
- SRS
- Starting (W/O Smart Key System)
- Theft Deterrent
- Illumination, Taillight
- Tire Pressure Warning System
- Turn Signal And Hazard Warning Light
- Wireless Door Lock Control (W/O Smart Key System)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.