2017 Toyota 4Runner TRD ProFACTORY OEM SERVICE PROCEDURE

DTC P0604: Internal Control Module Random Access Memory (RAM) Error [08/2015 - ]: Procedure

  1. CHECK WHETHER DTC OUTPUT RECURS (P0604) 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine and ECT / Trouble Code.
    5. Read DTCs.
      RESULT

      Display (DTC Output) Proceed to
      P0604 A
      No output B

    Result: 

    A 

    REPLACE ECM 

    (Refer to REMOVAL [08/2015 - ] )

    Result: 

    B 

    CHECK FOR INTERMITTENT PROBLEMS 

    (Refer to CHECK FOR INTERMITTENT PROBLEMS [08/2015 - ] )

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.