2013 Toyota Sienna SEFACTORY OEM SERVICE PROCEDURE

On-Vehicle Inspection

  1. INSPECT FRONT ENGINE MOUNTING INSULATOR ASSEMBLY 
    1. Check the operation.
      1. Connect the Techstream to the DLC3.
      2. Start the engine.
      3. Turn the Techstream on.
      4. Enter the following menus: Powertrain / Engine / Active Test / Control the ACM Inhibit.
        Tester Display Test Part Control Range Diagnostic Note
        Control the ACM Inhibit ACM ON / OFF Test is possible while engine is idling
      5. Check if the front engine mounting insulator assembly operates in accordance with tester operation.

        OK

        Condition Specified Condition
        "Control the ACM Inhibit" is OFF The engine does not move (insulator operation is normal).
        "Control the ACM Inhibit" is ON The engine moves in accordance with insulator operation.

        HINT: 

        While "Control the ACM Inhibit" is ON, the front engine mounting insulator assembly operates repeatedly.

    2. Inspect for vacuum leaks.
      1. Disconnect the vacuum hose from the front engine mounting insulator assembly.
      2. Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 24 in.Hg) and wait for 1 minute.
        Fig 1: Inspecting Front Engine Mounting Insulator Assembly Using Vacuum Pump
        GTY294975Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Check that there is no change in the needle movement of the vacuum pump gauge.

        OK

        Vacuum pressure holds.

      4. Check that there is no fluid leakage caused by a break in the diaphragm.
      5. Reconnect the vacuum hose.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.