Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Toyota Prius TwoFACTORY OEM SERVICE PROCEDURE
Navigation Receiver: Removal: Removal
WARNING: This page is about a different variant/trim than selected.
- PRECAUTIONÂ NOTE:
- After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work. Refer to PRECAUTION .
- A Hard Disk Drive (HDD) is built into the navigation receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken for the following points when handling the navigation receiver assembly.
- When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.
- REMOVE REAR NO. 3 FLOOR BOARDÂ . Refer to REMOVAL - Step 2
- REMOVE DECK FLOOR BOX RHÂ . Refer to REMOVAL - Step 2
- REMOVE REAR NO. 3 FLOOR BOARD UPPER PLATEÂ . Refer to REMOVAL - Step 3
- DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINALÂ NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
- REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLYÂ . Refer to REMOVAL - Step 6
- REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLYÂ . Refer to REMOVAL - Step 7
- REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISHÂ . Refer to REMOVAL - Step 9
- REMOVE UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLYÂ . Refer to REMOVAL - Step 10
- REMOVE NAVIGATION RECEIVER WITH BRACKETÂ
- Remove the 4 bolts.
- Disengage the 4 claws and remove the navigation receiver with bracket as shown in the illustration.
- Disconnect each connector.
- REMOVE NO. 1 RADIO BRACKETÂ
- Remove the 4 screws and No. 1 radio bracket.
- REMOVE NO. 2 RADIO BRACKETÂ
- Remove the 4 screws and No. 2 radio bracket.
- REMOVE HARD DISK DRIVE See step  12
- REMOVE NAVIGATION ECU SUB-ASSEMBLYÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
