2013 Toyota Prius ThreeFACTORY OEM SERVICE PROCEDURE

Front Wheel Alignment: Adjustment: Adjustment

WARNING: This page is about a different variant/trim than selected.
NOTE:

If the wheel alignment has been adjusted, or if suspension or underbody components have been removed/installed or replaced, be sure to perform the following initialization procedure in order for the system to function normally:

  1. Perform zero point calibration of the yaw rate and acceleration sensor.
  1. INSPECT TIRES  . Refer to INSPECTION - Step 1
  2. MEASURE VEHICLE HEIGHT 
    Fig 1: Identifying Vehicle Height Dimensions
    GTY339247Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.