Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Toyota Prius ThreeFACTORY OEM SERVICE PROCEDURE
Fail-Safe Chart
WARNING: This page is about a different variant/trim than selected.
If a problem occurs in the power steering system, the power steering assist will be stopped, locked at a particular point, or decreased simultaneously to protect the system.
| DTC No. | DTC Detection Condition | Fail-safe |
|---|---|---|
| C1511/11 C1512/12 C1513/13 C1514/14 C1515/15 C1516/16 |
Torque sensor malfunction | Assist force restricted or power assist stopped |
| C1517/17 | Torque sensor malfunction | |
| C1524/24 | Motor malfunction | |
| C1531/31 C1532/32 |
Power steering ECU assembly malfunction | |
| C1533/33 | Temperature sensor malfunction in power steering ECU assembly | |
| C1534/34 | EEPROM abnormal | |
| C1535/35 | Steering wheel location data error | |
| C1551/51 | IG power source voltage error | Power assist stopped |
| C1552/52 | PIG power source voltage error | |
| C1553/53 | Overvoltage at IG and PIG terminals | |
| C1554/54 | Power source relay malfunction | |
| C1555/55 | Motor relay malfunction | |
| C1581/81 | ECU malfunction (Assist map number un-writing) | Permission of control assist map |
| C1582/82 | Assist map mismatch written in power steering ECU assembly | Controlled using current default map |
| U0129/93 | Lost communication with brake actuator assembly | Assist force restricted |
| U0293/92 | HV ECU communication error | Power assist stopped |
HINT:Β
- The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept in either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the power switch on (READY).
- If the auxiliary battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist will be reduced and the EPS warning light will come on. In such cases, the amount of power assist returns normal when the auxiliary battery voltage recovers.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
