2013 Toyota Prius Plug-inFACTORY OEM SERVICE PROCEDURE

Navigation Ecu: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL EXTENSION MODULE 
    1. Connect the connector to install the extension module.
    2. Connect each connector to install the navigation wire.
  2. INSTALL NO. 2 RADIO BRACKET  . Refer to INSTALLATION - Step 6
  3. INSTALL NO. 1 RADIO BRACKET  . Refer to INSTALLATION - Step 7
  4. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET  . Refer to INSTALLATION - Step 10
  5. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 27
  6. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH  . Refer to INSTALLATION - Step 28
  7. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 30
  8. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY  . Refer to INSTALLATION - Step 31
  9. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  10. INSTALL REAR NO. 3 FLOOR BOARD  . Refer to INSTALLATION - Step 58
  11. INSTALL REAR DECK FLOOR BOX  . Refer to INSTALLATION - Step 59
  12. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type)  . Refer to INSTALLATION - Step 60
Chapter Navigation
Return to Chapter: Installation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.