Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Toyota Prius FourFACTORY OEM SERVICE PROCEDURE
Diagnosis System
WARNING: This page is about a different variant/trim than selected.
- DESCRIPTION
- The certification ECU (smart key ECU assembly) controls the vehicle smart key system functions. Smart key system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). In some cases, a malfunction may be occurring in the smart key system. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.
- CHECK DLC3
- Check the DLC3. Refer to GENERAL INFORMATION .
- INSPECT AUXILIARY BATTERY VOLTAGE
- Measure the auxiliary battery voltage with the power switch off.
Standard Voltage
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery.
- Measure the auxiliary battery voltage with the power switch off.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
