2013 Toyota Prius FiveFACTORY OEM SERVICE PROCEDURE

Navigation Receiver: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. PRECAUTION 
    NOTE:

    When installing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. INSTALL NAVIGATION ECU SUB-ASSEMBLY 
  3. INSTALL HARD DISK DRIVE  See step  2
  4. INSTALL NO. 2 RADIO BRACKET 
    1. Install the No. 2 radio bracket with the 4 screws.
  5. INSTALL NO. 1 RADIO BRACKET 
    1. Install the No. 1 radio bracket with the 4 screws.
  6. INSTALL NAVIGATION RECEIVER WITH BRACKET 
    1. Engage the 4 claws and temporarily install the navigation receiver with bracket as shown in the illustration.
      Fig 1: Identifying Navigation Receiver With Bracket Claws
      GTY229012Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the navigation receiver with bracket with the 4 bolts.
  7. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 27
  8. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH  . Refer to INSTALLATION - Step 28
  9. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 30
  10. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY  . Refer to INSTALLATION - Step 31
  11. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  12. INSTALL REAR NO. 3 FLOOR BOARD UPPER PLATE  . Refer to INSTALLATION - Step 3
  13. INSTALL DECK FLOOR BOX RH  . Refer to INSTALLATION - Step 4
  14. INSTALL REAR NO. 3 FLOOR BOARD  . Refer to INSTALLATION - Step 55
  15. INSPECT HARD DISK DRIVE 

    Refer to OPERATION CHECK

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.