2013 Toyota Highlander Limited, AWDFACTORY OEM SERVICE PROCEDURE

Engine Coolant Temperature Sensor: Inspection: Inspection

  1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR 
    1. Measure the resistance according to the value(s) in the table below.
      Fig 1: Identifying Engine Coolant Temperature Sensor
      GTY193734Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 2.32 to 2.59 kΩ
      80°C (176°F) 0.310 to 0.326 kΩ

      If the result is not as specified, replace the engine coolant temperature sensor.

      NOTE:

      When checking the engine coolant temperature sensor in water, do not allow water to go into the terminals. After checking, dry the engine coolant temperature sensor.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.