Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Toyota Highlander Limited, AWDFACTORY OEM SERVICE PROCEDURE
Active Control Engine Mount: Removal: Removal
- REMOVE V-BANK COVER SUB-ASSEMBLYÂ . Refer to REMOVAL - Step 25
- REMOVE ENGINE UNDER COVER ASSEMBLYÂ . Refer to REMOVAL - Step 7
- REMOVE NO. 1 ENGINE UNDER COVERÂ . Refer to REMOVAL - Step 8
- DRAIN ENGINE COOLANTÂ . Refer to REPLACEMENT - Step 4
- REMOVE COOL AIR INTAKE DUCT SEALÂ . Refer to REMOVAL - Step 1
- REMOVE BATTERYÂ . Refer to REMOVAL - Step 2
- REMOVE NO. 2 AIR CLEANER INLETÂ . Refer to REMOVAL - Step 3
- REMOVE NO. 1 AIR CLEANER INLETÂ . Refer to REMOVAL - Step 4
- DISCONNECT NO. 1 RADIATOR HOSEÂ . Refer to REMOVAL - Step 9
- DISCONNECT NO. 2 RADIATOR HOSEÂ . Refer to REMOVAL - Step 10
- DISCONNECT OIL COOLER HOSEÂ . Refer to REMOVAL - Step 11
- DISCONNECT COOLING FAN ECU CONNECTORÂ . Refer to REMOVAL - Step 12
- REMOVE RADIATOR GRILLE SUB-ASSEMBLYÂ . Refer to REMOVAL - Step 2
- REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)Â . Refer to REMOVAL - Step 5
- REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)Â . Refer to REMOVAL - Step 6
- REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLYÂ . Refer to REMOVAL - Step 16
- SEPARATE COOLER CONDENSER ASSEMBLYÂ . Refer to REMOVAL - Step 17
- REMOVE RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTORÂ . Refer to REMOVAL - Step 18
- REMOVE TRANSVERSE ENGINE MOUNTING BRACKETÂ
HINT:Â
Securely support the automatic transaxle using a jack.
- Remove the nut, 3 bolts and the transverse engine mounting bracket.
- REMOVE FRONT ENGINE MOUNTING INSULATOR ASSEMBLYÂ
- Disconnect the vacuum hose sub-assembly from the air cleaner cap sub-assembly and vacuum switching valve.
- Remove the 2 clamps.
- Disconnect the duty vacuum switching valve connector and clamp.
- Remove the cap, 3 nuts and front engine mounting insulator assembly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
