2013 Toyota 4Runner Limited, AWDFACTORY OEM SERVICE PROCEDURE

Throttle Body: Inspection: Inspection

  1. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY 
      Fig 1: Identifying Throttle Body Assembly Terminals
      GTY185807Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      2 (M+) - 1 (M-) 20°C (68°F) 0.3 to 100 Ω
      TEXT IN ILLUSTRATION

      *a Component without harness connected
      (Throttle Body with Motor)

      If the result is not as specified, replace the throttle body with motor assembly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.