2013 Toyota 4Runner Limited, AWDFACTORY OEM SERVICE PROCEDURE

Camshaft Oil Control Valve: Removal: Removal

  1. REMOVE V-BANK COVER  . Refer to REMOVAL - Step 6
  2. REMOVE NO. 1 AIR CLEANER HOSE  . Refer to REMOVAL - Step 7
  3. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Intake Side of Bank 1) 
    Fig 1: Identifying Camshaft Timing Oil Control Valve Assembly (For Intake Side Of Bank 1)
    GTY223395Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the oil control valve connector.
    2. Remove the bolt and oil control valve.
    3. Remove the O-ring from the oil control valve.
  4. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Exhaust Side of Bank 1) 
    Fig 2: Identifying Camshaft Timing Oil Control Valve Assembly (For Exhaust Side Of Bank 1)
    GTY234775Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the oil control valve connector.
    2. Remove the bolt and oil control valve.
    3. Remove the O-ring from the oil control valve.
  5. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Intake Side of Bank 2) 
    Fig 3: Identifying Camshaft Timing Oil Control Valve Assembly (For Intake Side Of Bank 2)
    GTY189708Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the oil control valve connector.
    2. Remove the bolt and oil control valve.
    3. Remove the O-ring from the oil control valve.
  6. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Exhaust Side of Bank 2) 
    Fig 4: Identifying Camshaft Timing Oil Control Valve Assembly (For Exhaust Side Of Bank 2)
    GTY223396Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the oil control valve connector.
    2. Remove the bolt and oil control valve.
    3. Remove the O-ring from the oil control valve.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.