Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Toyota 4Runner Limited, AWDFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Chart
HINT:Β
If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See" below.
POWER WINDOW CONTROL SYSTEM
| DTC Code | Detection Item | Trouble Area | See |
|---|---|---|---|
| B2311 | Power Window Motor Malfunction | - Front power window regulator motor LH - Front power window regulator motor RH - Rear power window regulator motor LH - Rear power window regulator motor RH |
Refer to DTC B2311: Power Window Motor Malfunction |
| B2312 | Power Window Switch Malfunction | - Multiplex network master switch - Power window regulator switch - Rear power window regulator switch LH - Rear power window regulator switch RH - Front power window regulator motor LH - Front power window regulator motor RH - Rear power window regulator motor LH - Rear power window regulator motor RH - Harness or connector |
Refer to DTC B2312: Power Window Switch Malfunction |
| B2313 | Glass Position Initialization Incomplete | - Front power window regulator motor LH - Front power window regulator motor RH - Rear power window regulator motor LH - Rear power window regulator motor RH |
Refer to DTC B2313: Glass Position Initialization Incomplete |
| B2311 | Back Door Power Window ECU Inner Motor Failure | - Back door power window regulator motor | Refer to DTC B2311: Back Door Power Window ECU Inner Motor Failure |
| B2312 | Back Door Power Window Switch ON Stuck | - Back door power window regulator motor - Multiplex network door ECU (back door P/W) - Harness or connector |
Refer to DTC B2312: Back Door Power Window Switch ON Stuck |
| B2313 | Back Door Power Window Position/Seal Characteristics Data is not Memorized | - Back door power window regulator motor | Refer to DTC B2313: Back Door Power Window Position/Seal Characteristics Data is not Memorized |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
