2012 Toyota Venza FWD V6-3.5L (2GR-FE)FACTORY OEM SERVICE PROCEDURE

Removal





2GR-FE ENGINE CONTROL: ECM: REMOVAL

NOTICE:
Perform the Vehicle Identification Number (VIN) registration when replace the ECM Repair Instruction - Initialization.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

3. REMOVE ECM

(a) Disconnect the 2 ECM connectors and remove the ECM with the brackets.

Factory service manual diagram




NOTICE:
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.

(1) Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.

(b) Remove the 3 nuts and separate the ECM with the brackets.

Factory service manual diagram




(c) Remove the 4 screws and 2 ECM brackets.

Factory service manual diagram



Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.