Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Toyota Tacoma X-RunnerFACTORY OEM SERVICE PROCEDURE
Quick Lookups: Fluids
| FLUID CAPACITIES | |||||||
|---|---|---|---|---|---|---|---|
| Fluid Type | Application | Standard | Metric | Fluid Spec | Note | S/H | |
| Air Cond Compressor Oil | 5.60 OZS. | 0.16 L | PAG 46 | Approximate capacity. | S | ||
| Air Cond Refrigerant | 1.32 LBS. | 0.59 KG | HFC-134a (R-134a) | S | |||
| Brake Fluid | N/A | N/A | SAE J1703 or FMVSS No. 116 DOT 3 | S | |||
| Clutch Fluid | N/A | N/A | SAE J1703 or FMVSS No. 116 DOT 3 | S | |||
| Differential Gear Oil | Base,X-Runner,RWD | Rear | 3.66 QTS. | 3.46 L | TOYOTA Genuine Differential Gear Oil LT SAE 75W-85 GL-5 or equivalent | S | |
| Engine Coolant | 4.0L Eng,Standard Trans | 10.30 QTS. | 9.74 L | TOYOTA Super Long Life Coolant or similar high-quality ethylene glycol-based non-silicate, non-amine, non-nitrate and non-borate coolant with long-life hybrid organic acid technology | DO NOT use plain water alone. The fluid capacity is the quantity of reference. | S | |
| Engine Oil | 4.0L Eng,RWD | Drain and Refill,w/Filter | 4.80 QTS. | 4.54 L | TOYOTA Genuine Motor Oil. SAE 5W-30 or equivalent ILSAC multigrade oil | SAE 5W-30 is the best choice for good fuel economy and good starting in cold weather. If SAE 5W-30 is not available, SAE 10W-30 oil may be used. However, it should be replaced with SAE 5W-30 at the next oil change. | S |
| Engine Oil | 4.0L Eng,RWD | Drain and Refill,w/o Filter | 4.40 QTS. | 4.16 L | TOYOTA Genuine Motor Oil. SAE 5W-30 or equivalent ILSAC multigrade oil | SAE 5W-30 is the best choice for good fuel economy and good starting in cold weather. If SAE 5W-30 is not available, SAE 10W-30 oil may be used. However, it should be replaced with SAE 5W-30 at the next oil change. | S |
| Fuel Tank | 21.10 GALS. | 79.87 L | S | ||||
| Manual Transmission Fluid | 4.0L Eng | 1.90 QTS. | 1.79 L | API - GL-4 or GL-5, SAE 75W-90 | S | ||
| Power Steering Fluid | N/A | N/A | Automatic Transmission Fluid DEXRON II or DEXRON III | S | |||
| Transfer Case Fluid | 1.10 QTS. | 1.04 L | API - GL-4 or GL-5, SAE 75W-90 | S | |||
| Windshield Washer Fluid | N/A | N/A | Washer Fluid | In cold areas where temperatures range below the freezing point, use washer fluid containing antifreeze. | S | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
