Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Toyota Tacoma X-RunnerFACTORY OEM SERVICE PROCEDURE
Engine Control System (1GR-FE) (Service Information): ECM: Removal: Removal
NOTE:
- Perform RESET MEMORY (AT initialization) when replacing the automatic transmission assembly, engine assembly or ECM. Refer to INITIALIZATION .
- Perform REGISTRATION (VIN registration) when replacing the ECM. Refer to REGISTRATION .
- If the ECM has been replaced or RESET MEMORY (AT initialization) has been performed, set up the function of the ATF (Automatic Transmission Fluid) temperature warning light. Refer to INITIALIZATION .
- Perform the Throttle body initialization when replacing the ECM See step 7.
- REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY . Refer to REMOVAL - Step 43
- REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER RH . Refer to REMOVAL - Step 44
- REMOVE ECM
- Disconnect the 6 ECM connectors, 6 No. 2 junction block connectors and wire harness clamp.
- Remove the 2 bolts and nut and the ECM.
- REMOVE NO. 2 JUNCTION BLOCK
- Remove the bolt.
- Disengage the claw and remove the No. 2 junction block.
- REMOVE NO. 2 ECM BRACKET
- Remove the 2 screws and the No. 2 ECM bracket.
- REMOVE ECM BRACKET
- Remove the 2 screws and the ECM bracket.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
