Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Toyota Sienna SEFACTORY OEM SERVICE PROCEDURE
Pre-Collision System: Precaution: Precaution
- TROUBLESHOOTING PRECAUTIONSÂ
- If a terminal contact point malfunction or part installation problem occurs, removal and reinstallation of the suspected part may return the system to normal. However, be aware that the normal condition may only be temporary.
- Before disconnecting connectors or removing/installing parts, determine the malfunctioning area by checking and writing down the vehicle condition at the time of the malfunction (DTC outputs etc.).
- Be sure to check for DTCs related to other systems. The pre-collision system may be influenced by malfunctions in other systems.
- HANDLING PRECAUTIONSÂ
- When removing and installing the ECU, sensor, switch or other pre-collision system related parts, perform the following:
- Make sure the ignition switch is off unless otherwise specified in the inspection procedure.
- After the removal/installation, check for DTCs and confirm that a normal system code is output.
- When removing and installing the ECU, sensor, switch or other pre-collision system related parts, perform the following:
- IGNITION SWITCH EXPRESSIONSÂ
- The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this information.
Expression Ignition Switch (Position) Engine Switch (Condition) Ignition switch off LOCK Off Ignition switch ACC ACC On (ACC) Ignition switch ON ON On (IG) Engine start START Start
- The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this information.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
