Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Toyota RAV4 EV ELE-Electric EngineFACTORY OEM SERVICE PROCEDURE
Keyless Systems - Smart Key Specifications
T-SB-0033-13
February 19, 2013
Smart Key Specifications
Service Category
Vehicle Interior
Section
Theft Deterrent/Keyless Entry
Market
USA
Applicability
Introduction
Some customers may inquire about the frequency and power output of the SmartKey/Smart Entry Systems used on various models. The Smart Key/Smart Entry systems conform to all applicable FCC rules. This bulletin details the applicable specifications for these systems.
CAUTION
Implanted pacemakers, cardiac defibrillators, or other electrical medical devices may be affected by radio waves emitted by the Smart Key/Smart Entry Antenna (in detection area). Customers with concerns about these systems and their effects on implanted electronic medical devices should consult their physician or the device manufacturer. This information is also included in the Owner's Manual for each applicable model.
If necessary details on disabling the Smart Key/Smart Entry functions can be found in the appropriate vehicle Repair Manual. Refer to the Technical Information System (TIS) for additional details.
Warranty Information
Smart Key Detection Area
Specifications: Smart Key Antenna (Communication from Vehicle to Key)
Specifications: Smart Key Transmitter/Wireless Remote (Communication from Key to Vehicle)
© 2013 Toyota Motor Sales, USA
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.