2012 Toyota Prius VFACTORY OEM SERVICE PROCEDURE

System Diagram

Fig 1: Pre-Collision System Diagram
GTY343606Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
COMMUNICATION TABLE

Sender Receiver Signal Line
Driving Support ECU Assembly Seat Belt Control ECU
  • Pre-collision seat belt operation signal
  • Pre-collision system malfunction signal
CAN
Driving Support ECU Assembly Brake Booster with Master Cylinder (Skid Control ECU)
  • Brake assist standby signal
  • Pre-collision brake operation signal
  • Pre-collision alarm signal
CAN
Driving Support ECU Assembly Combination Meter Sub-assembly
  • Pre-collision system malfunction signal
  • Warning signal
  • Pre-collision brake off signal
CAN
Seat Belt Control ECU Combination Meter Sub-assembly Pre-collision system malfunction signal CAN
Brake Booster with Master Cylinder (Skid Control ECU) Driving Support ECU Assembly Vehicle speed signal CAN
Brake Booster with Master Cylinder (Skid Control ECU) Seat Belt Control ECU
  • Vehicle speed signal
  • Seat belt operation signal
  • Stop light switch signal
CAN
Yaw Rate Sensor Driving Support ECU Assembly Vehicle yaw rate sensor signal CAN
Seat Belt Control ECU Driving Support ECU Assembly Pre-collision system malfunction signal CAN
Main Body ECU (Multiplex Network Body ECU) Seat Belt Control ECU Vehicle type signal (steering wheel position) CAN
Main Body ECU (Multiplex Network Body ECU) Driving Support ECU Assembly Vehicle specification information (destination, steering wheel position) CAN
Steering Angle Sensor Driving Support ECU Assembly Steering angle sensor signal CAN
Center Airbag Sensor Assembly Seat Belt Control ECU Buckle switch signal CAN
Power Management Control ECU Driving Support ECU Assembly
  • Shift position signal (D, R)
  • Engine type information signal
  • Vehicle specification information (2WD/AWD information)
CAN
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.