Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Toyota Prius TwoFACTORY OEM SERVICE PROCEDURE
Section 71 (Seats (Plug-In) (Service Information))
WARNING: This page is about a different variant/trim than selected.
- FRONT SEAT ASSEMBLY (for Manual Seat)
- FRONT SEAT ASSEMBLY (for Power Seat)
- Rear Seat Assembly
- Power Seat Switch
- Lumbar Switch
- Seat Heater Switch
- FRONT SEATBACK HEATER (for Manual Seat)
- FRONT SEATBACK HEATER (for Power Seat)
- FRONT SEAT CUSHION HEATER (for Manual Seat)
- FRONT SEAT CUSHION HEATER (for Power Seat)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.