Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Toyota Prius TwoFACTORY OEM SERVICE PROCEDURE

Cruise Control Main Switch: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE STEERING PAD
Refer to REMOVAL
REMOVE CRUISE CONTROL MAIN SWITCH
1. Remove the 2 screws.
  
  Fig 1: Identifying Cruise Control Main Switch & Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disengage the clamp and disconnect the connector.
  
  Fig 2: Identifying Clamp & Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the cruise control main switch.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.