Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Toyota Prius ThreeFACTORY OEM SERVICE PROCEDURE
Problem Symptoms Table
HINT:Β
- Use the table below to help determine the cause of the problem symptoms. If multiple suspected areas are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
ELECTRONIC SHIFT LEVER SYSTEM
| Symptom | Suspected Area | See |
|---|---|---|
| The P position switch indicator light does not come on. | P position switch indicator light circuit | Refer to "P" Position Switch Indicator Light Circuit |
| The P position switch indicator light does not go off. | P position switch indicator light circuit | Refer to "P" Position Switch Indicator Light Circuit |
| A (P) lock malfunction message is displayed on the multi-information display. | CAN communication system (CAN bus branch wire malfunction) | Refer to HOW TO PROCEED WITH TROUBLESHOOTING |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
