Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Toyota Prius ThreeFACTORY OEM SERVICE PROCEDURE
Customize Parameters
WARNING: This page is about a different variant/trim than selected.
- CUSTOMIZE LIGHTING SYSTEM (INT)Β
- Customizing using the Techstream
HINT:Β
The following items can be customized.
NOTE:- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Customize Setting / Illuminated Entry.
- Select the setting by referring to the table below.ILLUMINATED ENTRY
Tester Display Default Content Setting Relevant ECU Lighting Time 15 s Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (ACC or IG).) 15 s, 7.5 s or 30 s Main body ECU (Multiplex network body ECU) I/L when ACC OFF ON Lights up power switch illumination, front interior lights and rear interior light when the power switch is turned from on (ACC or IG) to off. OFF or ON I/L ON W/Door Key Unlock ON Lights up power switch illumination, front interior lights, rear interior light and footwell lights when doors are unlocked using a mechanical key or door control transmitter. OFF or ON Room Light when Aprchd ON Lights up the power switch illumination, front interior lights and rear interior light when a key enters any actuation area around the doors. OFF or ON Inside Foot Light*1 ON ON/OFF of footwell light control function. OFF or ON Light Control*1 ON Dims (ON setting) or turns off (OFF setting) the footwell lights under the following conditions: - Power switch on (READY), shift state other than park (P) has been selected, and all doors closed.
OFF or ON Interior Light Control ON Lights up the power switch illumination, front interior light, rear interior light and footwell lights when the illuminated entry function is operating. OFF or ON - *1: w/ Footwell Light
- Customizing with the Multi-display (for Navigation Receiver Type)
- Turn the power switch on (IG).
- Enter the following menus: Setup / Vehicle / Vehicle Customization / Light Settings
- Select the setting by referring to the table below
Display Default Content Setting Relevant ECU Interior Lights Off Timer 15 sec. Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (ACC or IG)). Off, 7.5 sec., 15 sec., or 30 sec. Main body ECU (Multiplex network body ECU)
- Customizing using the Techstream
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
