2012 Toyota Prius Plug-inFACTORY OEM SERVICE PROCEDURE

Hard Disk Drive: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. PRECAUTION 
    NOTE:

    When installing the hard disc drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. INSTALL HARD DISK DRIVE 
    1. Insert the hard disk drive in the direction shown by the arrow in the illustration to install it.
      Fig 1: Installing Hard Disk Drive
      GTY331679Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Engage the 2 guides to temporarily install the cover.
    3. Install the cover with the 2 screws.
  3. INSTALL NO. 2 RADIO BRACKET (w/ Daytime Running Light)  See step  4
  4. INSTALL NO. 2 RADIO BRACKET (w/o Daytime Running Light)  See step  4
  5. INSTALL NAVIGATION RECEIVER WITH BRACKET (w/ Daytime Running Light)  See step  6
  6. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Daytime Running Light)  . Refer to INSTALLATION - Step 11
  7. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 27
  8. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH  . Refer to INSTALLATION - Step 28
  9. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 30
  10. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY  . Refer to INSTALLATION - Step 31
  11. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  12. INSTALL REAR NO. 3 FLOOR BOARD  . Refer to INSTALLATION - Step 58
  13. INSTALL REAR DECK FLOOR BOX  . Refer to INSTALLATION - Step 59
  14. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type)  . Refer to INSTALLATION - Step 60
  15. INSPECT HARD DISK DRIVE 

    for Navigation Receiver Type: Refer to OPERATION CHECK

    for Radio and Display Type: Refer to OPERATION CHECK

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.