Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Toyota Prius Plug-inFACTORY OEM SERVICE PROCEDURE
Stop Light Switch Circuit: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK STOP LIGHT (OPERATION)
- Confirm that the stop lights illuminate correctly.
OK
Stop light operation is normal
NG → See step 4
OK: Go to next step
- Confirm that the stop lights illuminate correctly.
- CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER CONTROLLER - STOP LIGHT CONTROL ECU ASSEMBLY)
- Disconnect the L140 vehicle approaching speaker controller connector.
- Disconnect the A28 stop light control ECU assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition L140-2 (STP) - A28-1 (OUT) Always Below 1 Ω L140-2 (STP) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 3
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE
- GO TO LIGHTING SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
