Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Customize Parameters
- CUSTOMIZE SMART KEY SYSTEM (for Start Function)
HINT:
The items in the table below can be customized.
NOTE:- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current setting before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
- Customizing with the Techstream
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Customize Setting.
- Select the setting by referring to the table below.SMART KEY / ACCESS
Tester Display Default Content Setting Relevant ECU Ignition Available Area All Function that switches the entry hybrid control system start detection area Front or All*1 Certification ECU (smart key ECU assembly) WARNINGTester Display Default Content Setting Relevant ECU Key Low Battery Warning ON Function that warns driver that the key battery is weak ON or OFF Certification ECU (smart key ECU assembly)
- Customizing with the multi-display (for Navigation Receiver Type)
- Turn the power switch on (IG).
- Enter the following menus: SETUP / Vehicle / Vehicle Customization / Door Lock Setting.
- Select the setting by referring to the table below.
Display Default Content Setting Relevant ECU Key System with Elec. Key On Function that enables or disables the smart key system. On or Off Certification ECU (smart key ECU assembly)
- Customizing with the multi-display (for Radio and Display Type)
- Turn the power switch on (IG).
- Enter the following menus: SETUP / Vehicle.
- Select the setting by referring to the table below.
Display Default Content Setting Relevant ECU Key System with Elec. Key On Function that enables or disables the smart key system. On or Off Certification ECU (smart key ECU assembly)
- Entry cancel function (manual operation).
The electrical key cancel operation disables the following functions:
- Entry Unlock/Lock
- Entry Hybrid Control System Start
- Entry System Back Door Open Function
- Key Lock-in Prevention
- Warning
- The operation procedure is as follows:
Precondition:
Power switch off, driver door closed and unlocked.
- Push the unlock switch of the key once.
- Open the driver door within 5 seconds.
- Push the unlock switch of the key twice within 5 seconds.
- Close and open the driver door twice within 30 seconds.
(Driver door: Close → Open → Close → Open)
- Push the unlock switch of the key twice within 5 seconds.
- Close and open the driver door within 30 seconds.
(Driver door: Close → Open)
- Close the driver door within 5 seconds.
When electrical key cancel is activated, the wireless door lock buzzer sounds twice.
To return to the original condition, perform the procedure again. When the original condition is returned, the wireless door lock buzzer sounds once.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.