2012 Toyota Prius Plug-inFACTORY OEM SERVICE PROCEDURE

System Diagram

Fig 1: Identifying Pre-Collision System Diagram
GTY335237Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
COMMUNICATION TABLE

Sender Receiver Signal Line
Driving Support ECU Seat Belt Control ECU
  • Pre-collision seat belt operation signal
  • Pre-collision system malfunction signal
CAN
Driving Support ECU Brake Booster with Master Cylinder (skid control ECU)
  • Brake assist standby signal
  • Pre-collision brake operation signal
  • Pre-collision alarm signal
CAN
Driving Support ECU Combination Meter
  • Pre-collision system malfunction signal
  • Warning signal
CAN
Seat Belt Control ECU Combination Meter Pre-collision system malfunction signal CAN
Brake Booster with Master Cylinder (Skid Control ECU) Driving Support ECU Vehicle speed signal CAN
Brake Booster with Master Cylinder (Skid Control ECU) Seat Belt Control ECU
  • Vehicle speed signal
  • Seat belt operation signal
CAN
Yaw Rate Sensor Driving Support ECU Vehicle yaw rate sensor signal CAN
Seat Belt Control ECU Driving Support ECU Pre-collision system malfunction signal CAN
Main Body ECU Seat Belt Control ECU Vehicle type signal (Steering wheel position) CAN
Main Body ECU Driving Support ECU Vehicle specification information (destination, steering wheel position) CAN
Steering Angle Sensor Driving Support ECU Steering angle sensor signal CAN
Center Airbag Sensor Seat Belt Control ECU Buckle switch signal CAN
Power Management Control ECU Driving Support ECU
  • Shift position signal (D, R)
  • Engine type information signal
  • Vehicle specification information (2WD/AWD information)
CAN
Millimeter Wave Radar Sensor Driving Support ECU
  • Front obstacle recognition signal
  • Distance signal
  • Relative speed signal
CAN
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.