2012 Toyota Prius Plug-inFACTORY OEM SERVICE PROCEDURE

System Diagram

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Power Window Control System Wiring Diagram
GTY225975Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
COMMUNICATION TABLE

Transmitting ECU Receiving ECU Signal Communication Method
Multiplex network master switch assembly Power window regulator motor assembly (for driver side) Power window auto up and down signal LIN
  • Power window regulator motor assembly (for front passenger side)
  • Power window regulator motor assembly (for rear LH side)
  • Power window regulator motor assembly (for rear RH side)
Power window remote up and down signal LIN
Main body ECU (multiplex network body ECU)
  • Power window regulator motor assembly (for driver side)
  • Power window regulator motor assembly (for front passenger side)
  • Power window regulator motor assembly (for rear LH side)
  • Power window regulator motor assembly (for rear RH side)
Power window operation permission signal LIN
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.