2012 Toyota Prius Plug-inFACTORY OEM SERVICE PROCEDURE

Heated Oxygen Sensor: Removal: Removal

  1. REMOVE NO. 3 ENGINE UNDER COVER 
    1. Remove the 4 clips and No. 3 engine under cover.
      Fig 1: Identifying Front No. 3 Engine Under Cover & Clips
      GTY225062Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE HEATED OXYGEN SENSOR 
    1. Disconnect the heated oxygen sensor connector.
      Fig 2: Identifying Heated Oxygen Sensor Connector & Grommet
      GTY235122Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the grommet and pull the sensor connector out of the cabin through the floor panel.
    3. Remove the wire harness clamp bracket and disconnect the wire harness clamp.
      Fig 3: Identifying Wire Harness Clamp Bracket & Harness Clamp
      GTY235054Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Using SST, remove the heated oxygen sensor.
      Fig 4: Identifying SST & Heated Oxygen Sensor
      GTY229997Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00010 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.