Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Toyota Prius FourFACTORY OEM SERVICE PROCEDURE
General Maintenance
- GENERAL NOTESÂ
- Maintenance requirements vary depending on the country.
- Check the maintenance schedule in the owner's manual supplement.
- Following the maintenance schedule is mandatory.
- Determine the appropriate time to service the vehicle using either miles driven or time (months) elapsed, whichever reaches the specification first.
- Maintain similar intervals between periodic maintenance unless noted.
- Failing to check each maintenance item could lead to poor engine performance and increase exhaust emissions.
- WINDSHIELD WASHER FLUIDÂ
- Check that there is sufficient fluid in the tank.
- ENGINE COOLANT LEVELÂ
- Check that the coolant level is between the "FULL" and "LOW" lines on the see-through reservoir.
- INVERTER COOLANT LEVELÂ
- Check that there is sufficient fluid in the tank.
- RADIATOR AND HOSESÂ
- Check that the front of the radiator is clean and not blocked by leaves, dirt and bugs.
- Check the hoses for cracks, kinks, rot or loose connections.
- BRAKE FLUID LEVELÂ
- Check that the brake fluid level is near the upper level line on the see-through reservoirs.
- ENGINE OIL LEVELÂ
- Check that the level of engine oil is between "F" and "L" on the dipstick with the engine turned off.
- HYBRID TRANSAXLE FLUID LEVELÂ
- Check the level of the hybrid transaxle fluid. Refer to REPLACEMENT - Step 3 .
- EXHAUST SYSTEMÂ
- Visually inspect for severe corrosion, cracks, holes or loose supports.
HINT:Â
If any change in the sound of the exhaust or smell of the exhaust fumes is noticed, inspect and repair the exhaust system.
- Visually inspect for severe corrosion, cracks, holes or loose supports.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
